- Cable & Wire Rope
- Door Hardware
- Rigging Hardware
- New Products
- By Industry
- By Catalog
- Contact us
- My Account
96" Earth Anchor w / 10" Helix, 1-1 / 4" Rod, HG
Helix OD: 10"
Rod OD: 1-1/4"
Typical Working Torque 1-1/4" rod 2,300 ft-lbs.
Finish: Galvanized corrosion resistance
Weight: 42 lbs.
Must be sent LTL due to length
Approx. Holding Capacities (see Soil Classifications):
Class 5: 13,000 lbs.
Class 6: 10,000 lbs.
Class 7: 7,000 lbs.
Anchors are installed by simply turning the anchor into the ground, utilizing a turning bar placed through the anchor's forged eye. No Wrench Utility Anchors can be installed by hand or by machine.
Screw Anchors consist of a forged triple eye rod with an angled point, and a firmly welded helix.
Ground Anchors are hot dipped galvanized to meet ASTM Specification A153, Class C for long resistance to rust
Class 5: Medium dense coarse sand and sandy gravels; stiff to very stiff silts and clays Saprolites, residual soils
Class 6: Loose to medium dense fine to coarse sand; firm to stiff clays and silts Dense hydraulic fill; compacted fill; residual soils
Class 7: Loose fine sand; Alluvium; loess; soil-firm clays; varied clays; fill Flood plain soils; lake clays; adobe; gumbo; fill
Anchor requirements are site specific. Soil type should be determined to assure that the correct anchors are used. Seek professional guidance. Anchors must be installed at an angle of 45 degrees in the direction of the guy load. Failure to install within 5 degrees of alignment of the guy load will significantly lower strength. Capacity ratings apply to properly installed anchors only.
SAFETY FIRST: Calling 811 before every digging job gets your underground utility lines marked for free. For more information visit: www.digsafe.com